OUTHOUSE 28mm

A few people have asked me about the outhouse in one the images in my previous picket fence post.
Its from Laser Shark Design which sponsored our last Chain of Command event at CANCON here in Australia.
They are nice little additions to the gaming table and 
in-expense at ($5 AUD,$3.41 USD 2.65 Pound Stirling) for two Outhouses. 

Here are some more examples, there are made from MDF and were very easy to put together.

I replaced one of the roofs on the left with some corrugated paper.

The 2 on the right have been painted straight out of the box , the 2 on the left have been etched with my hand motor before the paint has been applied.

Painting the Outhouse.

Primed with spray can of Black primer.

I applied the paint using a wet painting technique, similar to dry brushing but you load up your brush with more paint and a bit more careful with the application of the paint and opposed to the more rough application when dry brushing.

The base coats used were Vallejo model colour Iquai Sand and Green Grey.

To highlight I added white to the mix to increasing portions and highlighted till I was happy with the results.  

PVA glue was applied to the base and flocked.

Cheers John